Dial Gauge Shaft Alignment Basic- BALTECH SA-4000
BALTECH SA-4000 is a tool kit for shaft alignment with dial indicators and without a unit for misalignment calculation. This is the kit for horizontal and vertical shaft alignment. This tool kit doesn't include a measurement unit and is recommended for use by experienced specialists. The measurements are conducted with dial indicators. The received data is used to calculate the misalignment amount. If you want to extend your system up to BALTECH SA-4100, BALTECH SA-4200 or BALTECH SA-4300 you only need to purchase a measurement unit. The universal fixtures and rods are mounted on the shafts without clearances.
1.
Horizontal shaft alignment
2.
Vertical shaft alignment
3.
Check and elimination of soft foot during alignment
4.
Alignment method selection: radiaxial method or dial indicator method
Technical Specifications
| Number of indicators (dial) | 2 |
| Sensor type | Dial indicator |
| Measurement range | Not less than 10 mm |
| Measurement accuracy | 0,01 mm |
| Maximum diameter of mating shafts (couplings):- with chains | 600 |
| - with magnets (options) | Not limited |
| Rod length | 320 mm |
